Rainier AWD L6-4.2L (2007)
Front Steering Knuckle: Service and Repair
Steering Knuckle Replacement (4WD)
Tools Required
^
J 24319-B Steering Linkage and Tie Rod Puller
^
J 43631 Ball Joint Remover
Removal Procedure
1. Remove the tire and wheel center cap.
2. Remove the drive axle nut.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
4. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
5. Remove the wheel hub and bearing. Refer to Wheel Hub, Bearing, and Seal Replacement (4WD) Wheel Hub, Bearing, and Seal Replacement
(RWD).
6. Remove and discard the outer tie rod retaining nut.
7. Disconnect the outer tie rod from the steering knuckle using J 24319-B.
