Rainier AWD L6-4.2L (2007)
Steering Gear: Service and Repair
Steering Gear Boot Replacement - Off Vehicle
Steering Gear Boot Replacement - Off Vehicle
Tools Required
J 22610 Keystone Clamp Pliers
Removal Procedure
1. Remove the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement.
2. Remove the rack and pinion gear. Refer to Power Steering Gear Replacement.
Important: All boot parts must be replaced when replacing the inner tie rod.
3. Remove and discard the small seal retaining clamp (1).
4. Remove and discard the large seal retaining clamp (1) from the rack and pinion boot (2) with side cutters.
Important: Do not cut the end of the boot or place a screwdriver between boot and tie rod.
5. Firmly pull rack and pinion boot (1) from the gear.
Discard the rack and pinion boot (1).
Installation Procedure
