Rainier AWD L6-4.2L (2007)
Important: You must install the smaller cylinder line into the valve housing (3) first.
4. Place the smaller cylinder line (2) into the valve housing (3).
Important: Hold the smaller cylinder line (2) in place. Do not torque the cylinder line nut (1).
5. Place the other end of the cylinder line at the gear tube end (4).
Finger tighten the cylinder line nut (1) on the smaller cylinder line.
Important: You must install the larger cylinder line into the valve housing (3) first.
6. Place the larger cylinder line (2) into the valve housing (3).
Important: Hold the larger cylinder line (2) in place. Do not torque the cylinder line nut (1).
7. Place the other end of the cylinder line at the gear tube end (4).
Finger tighten the cylinder line nut (1) on the larger cylinder line.
8. Place the cylinder line retaining plate (2) over the cylinder line beads at the valve end.
Notice: Refer to Fastener Notice.
9. Install the TORX(R) screw (1) into the cylinder line retaining plate (2) and tighten using an E 8 socket.
Tighten the screw to 12 N.m (106 lb in).
10. Tighten both cylinder line nuts (3) at the cylinder end.
