Rainier AWD L6-4.2L (2007)
Axle Beam: Service and Repair
Rear Axle Tie Rod Replacement
Rear Axle Tie Rod Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Raise and support the rear axle at the designed D-height. Refer to Trim Height Specifications.
Important: When disconnecting the rear axle tie rod, the air suspension system must be depressurized or the body may shift during the
repair.
3. If equipped with air suspension, depressurize the air suspension system. Refer to Air Suspension Depressurization.
4. Remove the rear axle tie rod to the axle mounting bolt and nut.
5. Remove the rear axle tie rod to frame mounting bolt and nut.
6. Remove the rear axle tie rod from the vehicle.
Installation Procedure
Important: When installing the rear axle tie rod the bushings inner sleeve off set (largest gap) is towards the rear axle.
1. Install the rear axle tie rod to the vehicle.
2. Install the rear axle tie rod to frame mounting bolt and nut.
