Rainier AWD L6-4.2L (2007)
1. Install the rear axle upper control arm.
2. Install the rear axle upper control arm to frame mounting bolt.
Notice: Refer to Fastener Notice.
3. Install the rear axle upper control arm to axle mounting nut and bolt.
Tighten the rear axle upper control arm mounting bolts to 131 N.m (97 lb ft).
4. If equipped with air suspension, connect the air suspension leveling sensor link to the rear axle upper control arm.
5. Remove the rear axle support.
6. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front End).
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
8. Lower the vehicle.
Rear Axle Lower Control Arm Replacement
Rear Axle Lower Control Arm Replacement
Removal Procedure
