Rainier AWD L6-4.2L (2007)
14. IMPORTANT: The windshield lower supports (1) have molded in locks with an adhesive strip (2) on the back side. If the windshield lower stops
have been removed, they must be replaced.
Remove the windshield lower supports (1) by using a flat-bladed tool, lightly prying upward in the middle until it releases, if damaged.
15. IMPORTANT: Keep the cutting edge of the tool against the window.
This will allow the urethane adhesive to be separated from the window.
-
Leave a base of urethane on the pinch-weld flange.
-
The only suitable lubrication is clear water.
-
Use J 24402-A , J 39032 or equivalent in order to remove the window.
16. Remove the bottom of the windshield from the urethane adhesive using a long utility knife or similar tool. Keep the cutting edge of the utility knife
against the glass. Do this from inside the vehicle.
17. With the aid of an assistant, remove the windshield (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install a stationary window into the opening.
