Rainier AWD L6-4.2L VIN S (2005)
Antenna Cable: Service and Repair
Coaxial Cable Replacement - Digital Radio
COAXIAL CABLE REPLACEMENT - DIGITAL RADIO
REMOVAL PROCEDURE
1. Remove the right windshield garnish molding.
2. Remove the instrument panel (I/P) trim pad.
3. Remove the right sunshade and inboard retaining clip.
4. Lower the front portion of the headliner.
5. Disconnect the electrical connectors from the digital radio antenna assembly.
6. Remove the right front door sill plate.
7. Remove the coaxial cable from the right windshield pillar (1).
8. Lower the right closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
9. Disconnect the coaxial cable from the digital radio receiver.
10. Remove the lower rose bud (2) from the cowl.
11. Securely attach a mechanics wire to the end of the coaxial cable (3).
12. The coaxial cable is routed through the cowl insulator access hole and positioned between the cowl and the I/P. In order to release the upper rose
bud (1), grasp the coaxial cable near the bottom of the windshield and carefully pull upward.
13. Leaving the mechanics wire routed behind the I/P, remove the mechanics wire from the coaxial cable.
14. Remove the coaxial cable from the vehicle.
INSTALLATION PROCEDURE
