Rainier AWD L6-4.2L VIN S (2005)
5.3.
Remove pin 39, cut off the cable terminal and insulate the end with tape (E). Fold back the cable and secure it with tape (F).
5.4.
Fit the connecting rail and end face.
5.5.
Plug in the connector (A) and secure the cables with cable ties (B).
6.
Install the floor console over the handbrake. Do not press the console down into place, but instead allow it to fit loosely.
7.
Install the switch:
7.1.
Install the switch for the roof lighting (B) and plug in its connector.
7.2.
Guide the connectors for the window lift module and rear seat heater, if equipped, through the hole for each respective unit. Plug in the
window lift module's connector and install the module (A).
7.3.
If equipped, connect the rear seat heater's connector and install the switch.
8.
Install the floor console:
