Rainier AWD L6-4.2L VIN S (2005)
2. Install the top regulator retaining bolt (1) through the keyhole slot (5) in the rear door inner panel.
3. Install the 2 lower regulator retaining bolts (2, 3).
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the bolts in the following sequence.
1. Tighten the lower regulator retaining bolt (3) to 10 N.m (89 lb in).
2. Tighten the upper regulator retaining bolt (1) to 10 N.m (89 lb in).
3. Tighten the middle regulator retaining bolt (2) to 10 N.m (89 lb in).
5. Connect the regulator cable retainer (4) on the door.
6. Connect the electrical connector to the rear window regulator motor.
7. Remove the tape and position the rear window to the regulator glass carrier plate.
8. Loosely tighten the regulator glass carrier bolts (2).
9. Operate the window upward to the full up position, ensuring the window remains in the run channels.
Tighten the regulator glass carrier bolts (2) to 10 N.m (89 ft in).
10. Install the water deflector.
11. Install the trim panel.
