Rainier AWD L6-4.2L VIN S (2005)
Install a new license plate pocket perimeter gasket onto the backside edge of the pocket housing as shown above, starting at the middle of the seal at the
top center of the pocket. This will ensure that the seal will be even. When properly installed, there will be 25-50 mm (1-2 in) on either side of the liftgate
release handle (2) that the seal (1) does not reach. DO NOT attempt to install the seal on the liftgate directly below the release handle.
Install the license plate pocket assembly onto the liftgate. Refer to the License Plate Pocket Replacement procedure in the Body Rear End (2006 MY and
prior) or Exterior Trim sub-section of SI. Modify the tightening sequence for the screws that retain the pocket assembly to the liftgate as follows:
Push the entire rear license plate pocket assembly upward in the opening of the liftgate. Inspect the perimeter gasket to see if it is properly retained.
Tighten
Tighten the rear license plate pocket assembly retaining nuts to 5 N.m (44 lb in) in the following order.
Tighten the upper left retaining nut first.
Tighten the upper right retaining nut second.
Tighten the three lower retaining nuts in any order.
Parts Information
