Rainier AWD L6-4.2L VIN S (2005)
Console: Service and Repair
Console Replacement
Console Replacement
Removal Procedure
1. Block the wheels to prevent the vehicle from moving.
2. Remove the rubber ash tray inserts and rubber mat from the console.
3. Remove the floor shift control knob.
4. Remove the center console shift lever bezel, Oldsmobile only.
5. Remove the console storage compartment.
6. Remove the center console retaining screws.
7. Adjust the parking brake to the full-up, or fully engaged position.
8. Release the 2 forward trim extensions ears attached to the lower IP-Oldsmobile only.
9. Slide the console rearward and raise the rear of the console in order to expose the electrical connectors.
10. Disconnect the electrical connectors as necessary.
11. Adjust the parking brake to approximately the halfway position.
12. Remove the center console from the vehicle.
Installation Procedure
1. Position the center console to the vehicle.
2. Adjust the parking brake to the full-up, or fully engaged position.
3. Connect the electrical connectors as necessary.
4. Lower the rear of the console and slide the console forward into position.
5. Ensure that the 2 retaining ears on the front extensions of the console are fully engaged to the lower IP-Oldsmobile only.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the center console retaining screws.
Tighten the screws to 2.5 N.m (22 lb in).
7. Install the console storage compartment.
8. Install the center console shift lever bezel.
9. Install the floor shift control knob.
10. Install the rubber ash tray inserts and rubber mat to the console.
