Rainier AWD L6-4.2L VIN S (2005)
Power Mirror Motor: Service and Repair
MOTOR REPLACEMENT - POWER MIRROR
REMOVAL PROCEDURE
1. Remove the mirror face.
2. Remove the screws retaining the mirror to the mirror housing.
3. Remove the mirror motor from the housing.
4. Disconnect the electrical connector from the mirror motor.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the mirror motor.
2. Install the mirror motor to the mirror housing.
3. Install the screws retaining the mirror motor to the housing.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the mirror motor screws to 10 N.m (88 lb in).
4. Install the mirror face.
