Rainier AWD L6-4.2L VIN S (2005)
1. Lubricate the new piston seals (3), the caliper bores, and the pistons (2) using clean brake fluid.
2. Install the piston seals (3). Ensure that the piston seals are not twisted in the caliper bore grooves.
3. Install the boot seals (1) on the pistons (2).
4. Install the pistons in the caliper bores.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the bleeder valve (5) in the caliper housing (6).
Tighten the bleeder valve to 12 Nm (110 inch lbs.).
6. Install the bleeder valve cap (4).
7. Install the boot seals into the caliper housing bores using the J 8092 and the J 43885.
