Rainier AWD L6-4.2L VIN S (2005)
1. If the brake caliper guide pin is to be reused, clean the brake caliper guide pin using denatured alcohol, or equivalent.
2. Dry the brake caliper guide pin using non-lubricated, filtered air.
3. Apply high temperature silicone brake lubricant to the brake caliper guide pin. DO NOT apply lubricant to the brake pad hardware.
4. Install the front brake caliper to the mounting bracket.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the front brake caliper guide pins bolts.
Tighten the front brake caliper guide pin bolts to 42 Nm (31 ft. lbs.).
6. Important: DO NOT reuse the metal/copper gaskets. Use only new copper gaskets.
Install the NEW metal/copper gaskets to the front brake caliper bolt.
7. Install the front brake hose bolt and gaskets.
Tighten the brake hose bolt to 40 Nm (30 ft. lbs.).
8. Bleed the hydraulic brake system.
9. Install the tire and wheel assembly.
10. Lower the vehicle. Refer to Vehicle Lifting.
