Rainier AWD L6-4.2L VIN S (2005)
3. Install the coolant heater to the engine block.
Tighten the coolant heater to 50 Nm (37 ft. lbs.).
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
4. Install the coolant heater cord to the heater (2).
5. Properly position the engine electrical harness bracket to the intake manifold.
6. Install the engine electrical harness bracket bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
