Rainier AWD L6-4.2L VIN S (2005)
Installation Procedure
1. Install a new camshaft cover seal.
2. Install new rubber ignition control module seals.
3. Install the camshaft cover and secure with the cam cover bolts.
Tighten the camshaft cover bolts to 10 Nm (89 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the ignition control modules and secure the modules with bolts.
Tighten the ignition coil bolts to 10 Nm (89 inch lbs.).
5. Connect the ignition control module electrical connectors.
6. Install the fuel injector electrical connectors.
7. Install the engine electrical harness housing (1).
