Rainier AWD L6-4.2L VIN S (2005)
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the left engine mount bracket and secure the bracket with the bolts (1).
Tighten the engine mount bracket bolts to 50 Nm (37 ft. lbs.).
4. Install the left engine mount onto the bracket.
5. Lower the engine onto the engine mounts.
6. Install the right and the left upper engine mount nuts (1).
Tighten the upper engine mount nuts to 70 Nm (52 ft. lbs.).
7. Raise the vehicle and remove the jack from under the vehicle.
8. Install the engine protection shield and secure the shield with the bolts.
9. Install the right and the left lower engine mount nuts.
Torque the lower engine mount nuts to 70 Nm (52 ft. lbs.).
10. Lower the vehicle.
11. Install the left shock module.
12. Install the MAP sensor (2).
13. Install the MAP sensor retainer (1) and the electrical connector.
