Rainier AWD L6-4.2L VIN S (2005)
Timing Cover: Service and Repair
Engine Front Cover Replacement
^
Tools Required
-
J 44219 Cover Alignment Pins
Removal Procedure
1. Drain the engine coolant.
2. Remove the cooling fan and the shroud in Engine Cooling.
3. Remove the drive belt.
4. Remove the water pump.
5. Remove the crankshaft balancer.
6. Remove the power steering pump.
7. Raise the vehicle. Refer to Vehicle Lifting.
8. Remove the oil pan.
9. Lower the vehicle.
10. Remove the 7 mm center bolt (1).
11. Loosen and remove the remaining engine front cover bolts.
12. Place two of the front cover bolts in the jack screw holes on the front cover and tighten the bolts evenly to release the front cover from the engine.
13. Remove the two bolts from the front cover.
14. Remove the oil pump.
15. Clean and Inspect the front cover.
Installation Procedure
1. Install the J 44219, onto the engine.
