Rainier AWD L6-4.2L VIN S (2005)
2. Apply a 3 mm (0.12 inch) bead of sealer GM P/N 12378521 to the trace grooves on back side of the engine front cover (1).
Important: The engine front cover must be installed within 10 minutes from when the sealer was applied.
3. Also apply sealant on the inside three bolt hole bosses on the cover.
4. Align the oil pump to the crankshaft sprocket splines.
5. Install the front cover.
6. Install the front cover bolts, tightening the center bolt last (1).
Tighten the front cover bolts to 10 Nm (89 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
7. Remove the J 44219.
8. Raise the vehicle. Refer to Vehicle Lifting.
9. Install the oil pan.
10. Lower the vehicle.
11. Install the power steering pump.
12. Install the crankshaft balancer.
13. Install the water pump.
14. Install the drive belt.
15. Install the cooling fan and shroud.
16. Fill the engine with coolant.
