Rainier AWD L6-4.2L VIN S (2005)
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the compressor hose to the connector through the driver wheel opening.
5. Install the nut.
Tighten
Tighten the nut to 48 N.m (35 lb ft).
6. Install the compressor suction hose to the stud on the engine.
7. Install the nut.
Tighten
Tighten the nut to 48 N.m (35 lb ft).
8. Install the compressor suction hose to the engine lift bracket.
9. Install the bolt.
Tighten
Tighten the bolt to 48 N.m (35 lb ft).
10. Connect the compressor suction hose (1) to the accumulator.
11. Install the compressor suction hose nut to the accumulator.
Tighten
Tighten the nut to 48 N.m (35 lb ft).
12. Install the sealing washers.
13. Connect the compressor hose assembly hose to the compressor (4).
14. Install the compressor hose assembly washers.
15. Install the retaining nut (3).
Tighten
Tighten the nut to 33 N.m (24 lb ft).
16. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
17. Leak test the fittings of the components using the J 39400-A.
