Rainier AWD L6-4.2L VIN S (2005)
1. Install the NEW power steering gear oil seal (1) to the power steering gear using the seal installation end of the J44586 (2).
2. Ensure the power steering gear oil seals (1) are fully seated in the power steering gear.
3. Lower the vehicle.
4. Install the power steering hose assembly to the vehicle.
5. Notice: Refer to Fastener in Service Precautions.
Install the power steering hose assembly to frame brackets retaining bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).
6. Install the power steering hose assembly bracket to the wheel well.
7. Install the power steering hose assembly bracket retaining bolt at the wheel well.
Tighten the bolt to 10 Nm (89 inch lbs.).
8. Install the fuse block.
9. Install the battery tray.
