Rainier AWD L6-4.2L VIN S (2005)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine shield.
3. Remove the electrical connector from the oil pressure switch.
4. Remove the oil pressure switch.
Installation Procedure
1. Install the oil pressure switch.
Tighten the oil pressure switch to 20 Nm (15 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the electrical connector to the oil pressure switch.
3. Install the engine shield.
4. Lower the vehicle.
