Rainier AWD L6-4.2L VIN S (2005)
Fuel: Testing and Inspection
Without Special Tool
ALCOHOL/CONTAMINANTS-IN-FUEL DIAGNOSIS (WITHOUT SPECIAL TOOL)
TEST DESCRIPTION
Water contamination in the fuel system may cause driveability conditions such as hesitation, stalling, no start, or misfires in one or more cylinders.
Water may collect near a single fuel injector at the lowest point in the fuel injection system and cause a misfire in that cylinder. If the fuel system is
contaminated with water, inspect the fuel system components for rust or deterioration.
Ethanol concentrations of greater than 10 percent can cause driveability conditions and fuel system deterioration. Fuel with more than 10 percent
ethanol could result in driveability conditions such as hesitation, lack of power, stalling, or no start. Excessive concentrations of ethanol used in
vehicles not designed for it may cause fuel system corrosion, deterioration of rubber components, and fuel filter restriction.
ALCOHOL IN FUEL TESTING PROCEDURE
The fuel sample should be drawn from the bottom of the tank so that any water present in the tank will be detected. The sample should be bright and
clear. If alcohol contamination is suspected then use the following procedure to test the fuel quality.
1. Using a 100 ml (3.38 oz) specified cylinder with 1 ml (0.034 oz) graduation marks, fill the cylinder with fuel to the 90 ml (3.04 oz) mark.
2. Add 10 ml (0.34 oz) of water in order to bring the total fluid volume to 100 ml (3.38 oz) and install a stopper.
3. Shake the cylinder vigorously for 10-15 seconds.
4. Carefully loosen the stopper in order to release the pressure.
5. Re-install the stopper and shake the cylinder vigorously again for 10-15 seconds.
6. Put the cylinder on a level surface for approximately 5 minutes in order to allow adequate liquid separation.
If alcohol is present in the fuel, the volume of the lower layer, which would now contain both alcohol and water, will be more than 10 ml (0.34 oz).
For example, if the volume of the lower layer is increased to 15 ml (0.51 oz), this indicates at least 5 percent alcohol in the fuel. The actual amount of
alcohol may be somewhat more because this procedure does not extract all of the alcohol from the fuel.
PARTICULATE CONTAMINANTS IN FUEL TESTING PROCEDURE
The fuel sample should be drawn from the bottom of the tank so that any water present in the tank will be detected. The sample should be bright and
clear. If the sample appears cloudy, or contaminated with water, as indicated by a water layer at the bottom of the sample, use the following procedure
to diagnose the fuel.
1. Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel.
2. Place the container on a level surface for approximately 5 minutes in order to allow settling of the particulate contamination. Particulate
contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as
black and irregular particles.
3. Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system. Refer to Fuel System Cleaning.
