Rainier AWD L6-4.2L VIN S (2005)
If water or coolant is found in the transmission, the following components MUST be replaced.
^
Replace all of the rubber type seals.
^
Replace all of the composition4aced clutch plate assemblies including the band.
^
Replace all of the nylon parts (Thrust Washers).
^
Replace the torque converter.
^
Thoroughly clean and rebuild the transmission, using new gaskets and oil filter.
^
Flush and flow check the transmission oil cooler using J 45096. Refer to Corporate Bulletin Number 02-07-30-052C or newer - Automatic
Transmission Oil Cooler Flush and Flow Test Essential Tool J 45096 TransFlow.
Replace the Transmission Fluid Filler Tube, Seal and Fluid Level Indicator WITH the transmission REMOVED from vehicle.
1.
Remove the transmission fluid filler tube from the transmission.
2.
Replace the transmission fill tube seal, P/N 1259475.
3.
Replace the transmission fill tube, P/N 15000220, following the appropriate SI Document for Transmission Installation.
4.
Replace the transmission fluid level indicator, P/N 15069769 when appropriate during the transmission installation.
Replace the Transmission Fluid Filler Tube, Seal and Fluid Level Indicator with the transmission in the vehicle.
1.
Remove the air cleaner outlet duct.
2.
Remove the transmission fluid level indicator from the filler tube.
3.
Remove the filler tube nut (2) located on the right side of the engine.
4.
Remove the filler tube from the vehicle.
