Rainier AWD L6-4.2L VIN S (2005)
5. Disconnect the fuel feed pipe (3) from the fuel rail.
NOTE: Refer to Fuel and Evaporative Emission (EVAP) Hose/Pipe Connection Cleaning Notice in Service Precautions.
6. Disconnect the evaporative emission (EVAP) purge pipe (1) from the EVAP canister purge valve.
7. Disconnect the integral clip (2) from the wire harness bracket.
8. Position the fuel feed pipe (3) above the PCM studs
9. Raise the vehicle. Refer to Vehicle Lifting.
10. Use the following procedure with two wheel drive (2WD):
1. Remove the transmission support.
2. Lower the transmission slightly.
3. Remove the EVAP/fuel hose/pipe assembly retaining bolt (3) from the transmission.
4. Disengage the EVAP/fuel hose/pipe assembly from the clip (1) at the rear of the transmission.
11. Use the following procedure with four wheel drive (4WD):
1. Remove the transfer case.
2. Remove the transmission support.
3. Lower the transmission slightly.
4. Remove the EVAP/fuel hose/pipe assembly retaining bolt (3) from the transmission.
5. Remove the EVAP/fuel hose/pipe assembly (2) from the clip at the rear of the transmission.
