Rainier AWD L6-4.2L VIN S (2005)
Body Control Module: Description and Operation
Retained Accessory Power (RAP)
RETAINED ACCESSORY POWER (RAP) DESCRIPTION AND OPERATION
SERIAL DATA CONTROL OF RETAINED ACCESSORY POWER (RAP)
The class 2 modules receive the power mode message from the body control module (BCM) over the serial data circuits, indicating when the retained
accessory power (RAP) power mode is current. The BCM monitors the ignition switch position, battery condition and passenger compartment doors
status to determine whether RAP should be initiated. The modules then support the operation of the systems under their control as required by their
RAP power mode operation.
RAP will end when one of the following conditions is met:
-
The BCM receives an input indicating the opening of any compartment door.
-
The BCM internal timer for the RAP expires after approximately 10 minutes.
-
The BCM detects a decrease in battery capacity below a prescribed limit.
The BCM then sends a serial data power mode message Off-Awake ending the RAP function.
The class 2 RAP functions are:
-
The power windows
-
The entertainment devices
-
The DIC
BCM/RELAY CONTROL OF RETAINED ACCESSORY POWER (RAP)
The BCM keeps the RAP relay energized during all power modes, except Off-Awake.
The devices powered through the RAP relay or controlled directly by BCM are:
-
The rear vent windows
-
The sunroof
The devices controlled by the BCM through the RAP supply voltage circuit are:
-
The power roof module (PRM)
-
The mid-gate glass
