Rainier AWD L6-4.2L VIN S (2005)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor Replacement
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the camshaft position (CMP) sensor electrical connector (1).
2. Remove the CMP sensor retaining bolt.
INSTALLATION PROCEDURE
1. Install the camshaft position (CMP) sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the CMP sensor bolt to 10 N.m (89 lb in).
2. Install the CMP sensor electrical connector (1).
