Rainier AWD L6-4.2L VIN S (2005)
^
(1) 9 Volt Battery (obtain locally)
1.
Remove the encoder motor (actuator) from the transfer case.
2.
Using the J-35616-5, attach the RED lead from the jumper harness to the Motor Control B terminal (pin E - wire color red) of the transfer case
encoder motor (actuator) wiring harness connector.
3.
Using the J-35616-5, attach the BLACK lead from the jumper harness to the Motor Control A terminal (pin D - wire color black) of the transfer
case encoder motor (actuator) wiring harness connector.
4.
Touch the battery terminals of the 9-volt battery to the battery terminals of the jumper harness. This will rotate the encoder motor shaft in either a
clockwise or counterclockwise rotation depending on battery orientation.
5.
Using the 9-volt battery, rotate the encoder motor (actuator) shaft until the keyway on the motor shaft is between the two reference lines as shown
in the picture. This orientates the encoder motor (actuator) to NEUTRAL for ease of assembly.
Note:
If available, another option is to rotate the encoder motor (actuator) shaft until a shipping plug from a new encoder motor (actuator) can be
installed.
6.
Install the encoder motor (actuator) on the control actuator lever shaft of the transfer case.
NVG 226 Transfer Case Encoder Motor (Actuator) Indexing Procedure
Tools Required:
^
(1) EL-49741 9 Volt Encoder Motor (Actuator) Jumper Harness (Tool can be obtained from SPX/Kent Moore.
^
(4) J-356165 Terminal Test Adapter (Test Probe)
^
(2) 9 Volt Battery (obtain locally)
1.
Remove the encoder motor (actuator) from the transfer case.
2.
Using the J-35616-5, attach the RED lead from one of the jumper harnesses to the Battery Positive Voltage terminal (pin F - wire color orange) of
the transfer case encoder motor (actuator) wiring harness connector.
3.
Using the J-35616-5, attach the BLACK lead from the jumper harness to the Lock Solenoid Control terminal (pin G - wire color tan) of the
transfer case encoder motor (actuator) wiring harness connector.
4.
Attach a 9-volt battery to this harness. You will hear the encoder motor (actuator) unlock.
