Rainier AWD L6-4.2L VIN S (2005)
1. Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install EBCM on to the BPMV.
2. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
Install the 4 new T-25 TORX screws in the EBCM.
Tighten the 4 T-25 TORX screws to 5 Nm (39 inch lbs.) in an X-pattern.
3. Install the 2 electrical connectors on the side of the EBCM.
4. Install the electrical connector on the back of the EBCM.
5. Lower the vehicle.
6. Revise the tire calibration using the Scan Tool Tire Size Calibration function.