Rainier AWD L6-4.2L VIN S (2005)
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the inflatable restraint roof rail module - left yellow 2-way inline connector and install the CPA.
3. Install the garnish molding.
4. Connect the side impact sensor yellow 2-way connector (5) located near the middle of the door.
5. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the middle of the door.
6. Install the left door trim panel.
7. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
8. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
1. The AIR BAG indicator will flash 7 times.
2. The AIR BAG indicator will then turn OFF.
9. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
