Rainier AWD L6-4.2L VIN S (2005)
Knock Sensor: Service and Repair
KNOCK SENSOR (KS) REPLACEMENT
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the knock sensor harness connector (4).
3. Remove the knock sensor retaining bolt (3).
4. Remove the appropriate knock sensor (1 or 2).
INSTALLATION PROCEDURE
1. Install the knock sensor (1 or 2) and the bolt (3).
NOTE: Refer to Component Fastener Tightening Notice in Service Precautions.
Tighten the sensor to 25 N.m (18 lb ft).
2. Connect the knock sensor harness connector (4).
3. Lower the vehicle.
