Rainier AWD L6-4.2L VIN S (2005)
10. Connect the fuse block harnesses to the wiring loops.
11. Install the power steering cooler hose (2) the power steering pump.
12. Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
Install the power steering pressure hose (1) to the power steering pump.
Tighten the power steering pressure hose fitting to 25 Nm (18 ft. lbs.).
13. Notice: Refer to Fastener in Service Precautions.
Install the power steering hose assembly to front crossmember bracket mounting bolt.
Tighten the bolt to 10 Nm (89 inch lbs.).
14. Raise the vehicle. Refer to Vehicle Lifting.
15. Install the power steering return hose and the power steering cooler hose to the power steering cooler.
16. Remove the power steering gear oil seals from the power steering gear using J44586.
17. Connect the power steering hose assembly to the power steering gear.
18. Install the power steering hose assembly to power steering gear retaining bolt.
Tighten the bolt to 12 Nm (106 inch lbs.).
19. Remove the drain pan from under the vehicle.
20. Lower the vehicle.
21. Bleed the power steering system.
