Rainier AWD L6-4.2L VIN S (2005)
5. Connect the ABS wheel speed sensor wiring harness to the upper control arm.
6. Connect the upper control arm to the steering knuckle
7. Install the upper ball joint to upper control arm pinch bolt and nut.
Tighten
Tighten the upper ball joint to upper control arm pinch bolt to 40 Nm (30 ft. lbs.).
8. Install the tire and wheel.
9. Lower the vehicle.
10. Check the front wheel alignment. Refer to Wheel Alignment Specifications.
Lower Control Arm Replacement
Lower Control Arm Replacement
Tools Required
^
J24319-B Steering Linkage and Tie Rod Puller
^
J43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the outer tie rod retaining nut.
