Rainier AWD L6-4.2L VIN S (2005)
7. Spread the shock module yoke at the pinch bolt using a flat bladed tool.
8. Remove the shock module yoke from the shock absorber.
Installation Procedure
1. Install the shock module yoke to the lower control arm stud and shock absorber.
2. Install the shock module yoke to shock absorber pinch bolt and nut.
Tighten the shock module yoke to shock absorber pinch bolt to 70 Nm (52 lb ft).
Notice: Refer to Fastener in Service Precautions.
3. Install the shock module yoke to lower control arm mounting nut.
Tighten the shock module yoke to lower control arm mounting nut to 110 Nm (81 lb ft).
4. Install the tire and wheel.
5. Lower the vehicle.
