Rainier AWD L6-4.2L VIN S (2005)
6. Trim off the air line at the electrical harness with a sharp cutting tool. Leave the remaining air line in the wiring harness.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
Important: Ensure the color on the air supply lines match the color on the air spring compressor for reassembly.
1. Install air line to the air compressor (1) using a new fitting.
Tighten
Tighten the air supply line fitting to 2.25 Nm (20 lb in).
2. Install the air spring compressor to frame mounting bolts.
Tighten
Tighten the bolts to 20 Nm (15 lb ft).
3. Install the air line to the air spring.
4. Attach the air line to the outside of the wiring harness using wire ties.
5. Lower the vehicle.
6. Install the air suspension system fuse.
