Rainier AWD L6-4.2L VIN S (2005)
Suspension Strut / Shock Absorber: Service and Repair
Front
Shock Module Replacement
This article has been updated by TSB# 06-03-08-011 dated August 28,2006.
Shock Module Replacement
Tools Required
^
J 36607 Ball Joint Separator
Removal Procedure
1. Remove the shock module upper retaining nuts.
2. Raise and support the vehicle.
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the coil springs.
3. Remove the tire and wheel.
4. Loosen the shock module yoke to lower control arm retaining nut.
5. Remove the shock module yoke from the lower control arm using J 36607.
