Rainier AWD L6-4.2L VIN S (2005)
6. Install the shock module yoke to lower control arm retaining nut.
Tighten
Tighten the shock module yoke to lower control arm retaining nut to 110 Nm (81 ft. lbs.).
7. Install the tire and wheel.
8. Lower the vehicle.
Shock, Shock Component, and/or Spring Replacement
Shock, Shock Component, and/or Spring Replacement
Tools Required
^
J45400 Strut Spring Compressor
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the shock module from the vehicle.
4. Remove the shock module yoke to shock absorber pinch bolt and nut.
5. Spread the shock module yoke at the pinch bolt using a flat-bladed tool.
6. Remove the shock module yoke from the shock absorber.
