Rainier AWD L6-4.2L VIN S (2005)
8.
Loosen the next two forward axle mounting bolts in order to gain proper clearance.
Important:
ONLY install ONE washer/shim in the most rearward mounting position as shown above.
9.
Install one washer/shim, P/N 2436165 between the front axle case/housing and the oil pan at the rear most mounting hole as shown above.
10.
Install the front axle to oil pan bolt.
Tighten
Tighten the three front drive axle mounting bolts to 85 N.m (63 lb ft).
11.
Clean the underside of the vehicle with appropriate cleaner.
12.
Remove the tape from the front driveshaft bearing caps.
13.
Align the reference marks made during removal.
14.
Install the propeller shaft to the front axle pinion yoke.
15.
Install the yoke retainers and the bolts.
Tighten
Tighten the front propeller shaft yoke clamp bolts to 20 N.m (15 lb ft).
16.
Remove the front axle oil fill plug.
17.
Fill the front drive axle with the proper fluid SAE 75W-90 Synthetic Axle Lubricant, P/N 89021677 (Canadian P/N 89021678) or equivalent,
meeting GM Specification 9986115.
Specification
The oil level should be between 0-13 mm (0-0.5 in) below the fill plug opening.
18.
Install the front axle oil fill plug.
Tighten
