Rainier AWD L6-4.2L VIN S (2005)
Seals and Gaskets: Service and Repair
Front Differential
Intermediate Shaft Bearing Assembly Oil Seal Replacement
Intermediate Shaft Bearing Assembly Oil Seal Replacement
Tools Required
^
J2619-01 Slide Hammer with Adapter
^
J29369-2 Bushing and Bearing Remover (2-3 inch)
^
J45225 Axle Seal Installer
^
J45359 Axle Seal Installer
^
J6125-B Slide Hammer
^
J8092 Universal Driver Handle 3/4 in - 10
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the right wheel drive shaft.
3. Install the J29369-2 (1) and the J6125-B (2) into the outboard, wheel drive shaft side, oil seal as shown.
4. Remove the outboard, wheel drive shaft side, inner shaft seal by pulling on the J6125-B (2).
5. To replace the inboard, oil pan side side, inner shaft seal, remove the intermediate shaft bearing assembly.
6. Install the intermediate shaft bearing assembly into a vise. Place shop towels in the vise in order to protect the intermediate shaft bearing assembly.
7. Install the J29369-2 (2) and the J2619-01 (1) into the inboard, oil pan side, oil seal as shown.
8. Remove the inboard, oil pan side, seal by pulling on the J2619-01 (1).
Installation Procedure
1. Install the new inboard, oil pan side, inner shaft seal on top of the seal bore.
