Rainier AWD L6-4.2L VIN S (2005)
2. Install the new seal using the J45225 (2) and the J8092 (1).
3. Install the intermediate shaft bearing assembly.
4. Install the new oil seal using the J45359 (2) and the J8092 (1).
Notice: The outboard intermediate shaft bearing assembly seal must be installed 0.9 - 1.1 mm (0.035 - 0.043 inch) below the surface of the
intermediate shaft bearing assembly housing bore. If the seal is not installed properly, damage to the seal may occur.
5. Install the right wheel drive shaft.
6. Lower the vehicle.
Differential Carrier Assembly Oil Seal and/or Bearing Replacement
Differential Carrier Assembly Oil Seal and/or Bearing Replacement
Tools Required
^
J2619-01 Slide Hammer with Adapter
^
J29369-1 Bushing and Bearing Remover
^
J29369-2 Bushing and Bearing Remover (2-3 inch)
^
J45232 Differential Bearing Adjuster Needle Bearing Installer - LH
^
J45233 Differential Bearing Adjuster Needle Bearing Installer - RH
^
J45225 Axle Seal Installer
^
J6125-B Slide Hammer
Removal Procedure
Important: The seals used in the differential carrier assembly have built in tabs that are used to retain the position of the differential side bearing
adjusters. When removing the seal, do not twist or rotate the seal or the preload on the differential case side bearings may be affected.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Drain the lubricant from the differential carrier assembly.
3. Remove the left wheel drive shaft.