Rainier AWD L6-4.2L VIN S (2005)
14.
Install the drive axle.
15.
Install the shock module and tighten the two upper retaining bolts.
Tighten
Tighten the bolts to 45 N.m (33 lb ft).
16.
Tighten the lower shock module yoke to the lower control arm.
Tighten
Tighten the yoke to 110 N.m (81 lb ft).
17.
Install the stabilizer shaft linkage.
Tighten
Tighten the stabilizer shaft linkage to 100 N.m (74 lb ft).
18.
Install the knuckle assembly and the lower ball joint nut. Install the intermediate shaft through the knuckle assembly. Install the upper ball joint to
the control arm and install the pinch bolt and nut.
Tighten
^
Tighten the pinch bolt to 40 N.m (30 lb ft).
^
Tighten the lower ball joint nut to 110 N.m (81 lb ft).
19.
Install the intermediate shaft nut.
Tighten
Tighten the nut to 140 N.m (103 lb ft).
20.
Install the tie rod end in the steering knuckle.
Tighten
Tighten the tie rod end to 45 N.m (33 lb ft).
21.
Install the brake caliper and brake hoses.
Tighten
Tighten the caliper bolts to 51 N.m (38 lb ft).
22.
Install and connect the harness.
23.
Inspect the fluid in the front differential housing. Add fluid as necessary.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
