Rainier AWD L6-4.2L VIN S (2005)
1. Install the transfer case control module (1) to the mounting bracket.
2. Connect the three electrical connectors to the transfer case control module.
3. Install the transfer case control module and mounting bracket to the instrument panel mag beam.
4. Install the left side closeout/insulator panel.
5. Install the access panel.
6. Program the transfer case shift control module. Refer to Transfer Case Control Module Reprogramming.
Transfer Case Control Module Reprogramming
Transfer Case Control Module Reprogramming
Set-up for Module Programming/Reprogramming
Important: Ensure that the vehicle battery is fully charged and that a battery charger is no longer connected. If performing this procedure for module
replacement, install new module before proceeding. Before reprogramming close the doors and wait two minutes to allow other modules to stop
communicating via the class 2 data line. Failure to due so could result in a failed reprogramming procedure.
^
Turn OFF all accessories.
^
Turn ON the ignition, with the engine OFF.
