Rainier AWD L6-4.2L VIN S (2005)
2. Align the front output shaft seal on the J45236-2 (1).
3. Using the J45236-1 (2), install the front output shaft seal.
4. Remove the J45236-1 and the J45236-2.
5. Install the dust shield on the front output shaft.
6. Install the front propeller shaft.
7. Inspect the transfer case fluid level.
8. Install the fuel tank shield, if equipped.
9. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
Tools Required
^
J37668-A Output Shaft Seal Installer (4401 & 4470 Transfer Case)
^
J45380 Transfer Case Rear Bushing Remover and Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.