Rainier AWD L6-4.2L VIN S (2005)
9. Disconnect the electrical connector from the window regulator.
10. Remove the regulator assembly from the endgate out the access hole.
Installation Procedure
1. Install the regulator assembly to the endgate through the access hole.
2. Connect the electrical connector to the window regulator.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the regulator side rails to the endgate by inserting the nuts (1) in the keyhole slots (2).
Tighten the regulator side rail nuts to 25 N.m (18 lb ft).
4. Install the bolt (3) retaining the regulator motor bracket to the endgate.
Tighten the regulator motor bracket bolt (3) to 10 N.m (89 lb in).
