Rainier AWD V8-5.3L VIN P (2004)
4. Install the inflator bezel to the trim panel.
5. Feed the auxiliary air outlet through the hole in the inflator bezel.
6. Install the auxiliary air outlet washer and retaining nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 2 N.m (18 lb in).
7. Install the inflator switch to the inflator bezel.
8. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
9. Align the locating tabs on the trim panel to the holes in the body.
10. Seat the clips that retain the trim panel to the body.
11. Install the seat belt lower anchor.
Tighten the anchor bolt to 70.0 N.m (52 lb ft).
12. Install the right rear door sill panel.
13. Install the lift gate sill plate.
14. Install the trim panel-rear quarter upper.
