Rainier AWD V8-5.3L VIN P (2004)
11. Remove the hog rings (1) from the bottom rear side of the cover.
12. Remove the 11 hog rings from the top side of the cover.
13. Remove the seat cushion trim cover and pad from the seat frame.
14. Remove the seat module retaining screw, if equipped.
15. Remove the seat module, if equipped.
16. Remove the seat cover from the seat cushion.
17. Remove the seat cushion from the seat pan.
Installation Procedure
1. Install the seat cushion to the seat pan.
2. Install the seat cover to the seat cushion.
3. Using a side to side motion, carefully pull the seat cushion cover onto the seat pan.
4. Install the seat module, if equipped.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the seat module retaining screw.
Tighten the screw to 5 N.m (44 lb in).
6. Install the 11 hog rings to the top side of the cover and pad.
7. Install the 2 hog rings (1) to the bottom rear side of the cover and pad.
