Rainier AWD V8-5.3L VIN P (2004)
NOTICE:
All camshaft journals are the same diameter so care must be used in removing or installing the camshaft to avoid damage to the camshaft
bearings.
3. Using the bolts as a handle, carefully install the camshaft into the engine block.
4. Remove the three bolts from the front of the camshaft.
Important: Install the retainer plate with the sealing gasket facing the engine block. The gasket surface on the engine block should be clean and free of
dirt and/or debris.
5. Install the camshaft retainer and bolts.
Tighten the bolts to 25 Nm (18 ft. lbs.).
Important: Properly locate the camshaft sprocket locating pin with the camshaft sprocket alignment hole.
The sprocket teeth and timing chain must mesh.
The camshaft and the crankshaft sprocket alignment marks MUST be aligned properly. Locate the camshaft sprocket alignment mark in the
6 o'clock position.
