Rainier AWD V8-5.3L VIN P (2004)
7. Install the EVAP/fuel hose/pipe bracket to the bellhousing stud.
NOTE: Refer to Fastener Notice in Service Precautions.
8. Install the EVAP/fuel hose/pipe bracket nut (2).
Tighten
Tighten the nut to 10 N.m (89 lb in).
9. Use the following procedure if the vehicle is equipped with 4WD:
9.1.
Install the EVAP/fuel hose/pipe assembly to the retaining clips (1) on the transmission.
9.2.
Raise the transmission to the normal installed height.
9.3.
Install the transmission support.
9.4.
Remove the transmission jack.
9.5.
Install the front propeller shaft.
9.6.
Install the transfer case.