Rainier AWD V8-5.3L VIN P (2004)
1. Install the shock absorber to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the shock absorber lower mounting bolt.
Tighten the shock absorber lower mounting bolt to 80 Nm (59 ft. lbs.).
3. Install the shock absorber upper mounting bolt.
Tighten the shock absorber upper mounting bolt to 80 Nm (59 ft. lbs.).
Important: Before removing the support from the rear axle, ensure that the air suspension leveling sensor link is in the correct position. If the air
suspension leveling sensor link is out of position, air suspension system failure will occur.
4. Remove the support from the rear axle.
5. Lower the vehicle.
Shock Absorber Disposal
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap
ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
Caution: To prevent personal injury, wear safety glasses when center punching and drilling the shock absorber. Use care not to puncture
the shock absorber tube with the centerpunch.
