Rainier AWD V8-5.3L VIN P (2004)
7. Install the J 8614-01 onto the pinion yoke as shown.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: If the rotating torque is exceeded, the pinion will have to be removed and a new collapsible spacer installed.
8. Tighten the pinion nut while holding the J 8614-01.
^
Tighten the pinion nut until the pinion end play is just taken up. Rotate the pinion while tightening the nut to seat the bearings.
9. Measure the rotating torque of the pinion using an inch-pound torque wrench.
Compare the measurement of the rotating torque to the measurement recorded earlier.
^
The rotating torque of the pinion nut should be 0.40 - 0.57 Nm (3 - 5 inch lbs.) greater than the torque recorded during removal.
10. If the rotating torque is not within specifications, continue to tighten the pinion nut.
^
Tighten the pinion nut, in small increments, as needed, until the torque required in order to rotate the pinion is 0.40 - 0.57 Nm (3 - 5 inch lbs.)
greater than the torque recorded during removal.
11. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
12. Install the rear steering gear crossmember.
13. Install the front propeller shaft.
14. Install the engine protection shield.
15. Inspect the axle lubricant level, and add, if necessary.
16. Lower the vehicle.
Carrier Assembly Oil Seal and/or Bearing Replacement
Differential Carrier Assembly Oil Seal and/or Bearing Replacement
^
Tools Required
-
J 02619-1 Slide Hammer with Adapter
-
J29369-1 Bushing and Bearing Remover
-
J 29369-2 Bushing and Bearing Remover (2-3 inch)
-
J 45232 Differential Bearing Adjuster Needle Bearing Installer-LH
-
J 45233 Differential Bearing Adjuster Needle Bearing Installer-RH
-
J 45225 Axle Seal Installer
-
J 6125-B Slide Hammer
Removal Procedure
Important: The seals used in the differential carrier assembly have built in tabs that are used to retain the position of the differential side bearing
adjusters. When removing the seal, do not twist or rotate the seal or the preload on the differential case side bearings may be affected.
